There's a fascination on the part of some architects with putting specifications on drawings. I've tried on several occasions in several firms to work out a reasonable way to routinely accomplish moving text material from MSWord files to AutoCAD drawings. If you like, I can ask my job captain here, because he did it for me. If the text style problem persists, you may have to create a custom text format in ACAD, which is just beyond my grasp. Word wrap also works, and individual character formatting (bold, italic etc.) You can get hanging indents and similar effects, but you may have to fiddle with it. To get the alignments to work, select all the text and tweak the ruler (sim to Word) until it all lines up. The ACAD editor window has some limited formatting abilities. The formatting should survive into ACAD if the font is available to ACAD. Format the text in Word the way you want it, then copy the text out of Word and paste it into the mtext box in ACAD. I can't remember which is which, but one is an expandable text box, (mtext I think).Ĭreate an Mtext box and stretch it out to suit the dimension of your drawing extent. There are two kinds of ACAD text, dtext and mtext. Robert: I am no ACAD whiz, so don't laugh too hard. Text that wraps would not align to left margin some spacing on same line of text would crowd up, etc.ĭid not experience any AutoCad effort to change style, height, etc. Suggestions, anyone? Success stories? Pitfalls to avoid? Thanks!ĭid some of this yesterday, and used same font and size as you note found that we had some relatively minor spacing and formatting problems. Upper & lower case is used for legibility, Arial Narrow for compactness.ĪutoCad seems to want to re-format the text in its own choice of character style, height, width, spacing etc., thwarting the intent.Įditing ability in AutoCad might be a nice bonus, but is not essential, since that could be done in Word, before importation. TrueType "Arial Narrow" upper & lower case) since its lower-case x-height is about 1/8", which we consider a minimum (1/16" at 11" x 17" half-size). We would like to preserve the Word doc formatting (17 pt. We have a standard limited-application spec in MS Word that would fill four 22" x 34" sheets, 6 columns per sheet. Of all the ways to import text into AutoCad, is there one that is best suited for "specs on drawings"? 4specs Discussion Forum: Import specs into AutoCad?Īrchive - Specifications Discussions #3 »
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |